Machine Kinematics
solved, then drawn
Concept

Epicycloid — where it appears

The curve a point on a circle traces as that circle rolls on the outside of another. It is half of the classical cycloidal tooth pair, and its conjugate under a constant ratio is the hypocycloid of the same rolling circle.

Named by 3 essays across one field — each of them below, with the objects they name alongside it.

The measurement every gear cut since 1900 is a consequence of. Take a pair that is conjugate at its design centre distance, move the shafts apart, and ask what shape the driven wheel would have to be for the ratio to hold. The involute wants the same shape at every distance — 2.91e-8 mm at two millimetres out, which is the comparison's own noise floor — because its shape is fixed by its base circle and the centre distance is not one of that circle's arguments. The cycloidal pair is conjugate at nought and wants a shape 6.71e-3 mm different at five hundredths of a millimetre out, because its describing circle has to roll between two pitch circles that are no longer touching. A bearing that wears, a housing bored a little wide, a case that warms up: all of them are this axis.

The shape that does not mind where the shafts are

Two tooth forms, both exactly conjugate, both in use for centuries. Move the shafts five hundredths of a millimetre apart and one of them wants a different shape and the other does not — and that single measurement is close to the whole reason every gear cut since about 1900 is an involute.

meshing · Meshing Eleven lobes from twelve pins, at 46° of eccentric. The pins are circles and the disc is their envelope. One turn of the eccentric moves the disc back by one lobe pitch — a reduction of 11 : 1 from a ring, a disc and an offset bearing, with no gear teeth anywhere — and the profile's 11 lobes are counted off the generated curve rather than put there. The roots sit at 50.00 mm and the tips at 60.00, which are R − r ∓ e: the eccentricity is the lobe height, twice over. positioned by solving, not by drawing.

Eleven lobes from twelve pins

A ring of round pins, a disc on an eccentric, and a reduction of eleven to one with no gear teeth anywhere. The disc's profile is not designed: one pin generates one lobe of it, the other ten lobes are the same curve, and the count that decides the ratio is a count of lobes on a shape nobody drew.

meshing · Meshing Two identical rotors in mesh, and the one place they touch. Two rotors, each with 2 cycloidal lobes on a pitch circle of radius 50, on centres 100 apart and turning at the same speed in opposite senses, drawn with the first turned −20°. Each rotor's roots were computed from its tips, and the mate is the same rotor turned. At this position they touch at one point, on the first rotor's tip, and the common normal there misses the pitch point by 2.2 × 10⁻¹⁰. The contact sits on the describing circle tangent to both pitch circles, within 8.5 × 10⁻¹⁰, so the normal is the chord from the pitch point to it. The normal's moment arm about the mate's shaft is 32.14, positive when the contact turns the mate forward.

Rotors that mesh and cannot drive each other

Two identical lobed rotors on shafts turning one to one are each other's conjugate: give half of a lobe and the meshing equation computes the other half so exactly that the rotor is its own mate. The pair holds its ratio at every instant and still cannot drive itself, because the one contact between them pushes the driven rotor backwards for exactly half of every turn.

meshing · Meshing

Named alongside it

The objects these essays reach for when they reach for this one.

Conjugate-actionBacklashDescribing circleEnvelopeHypocycloidLobeCentre distanceContact normalContact pointcycloidal motionCycloidal driveDead centre

All concepts