Machine Kinematics
solved, then drawn
Concept

Interchangeability — where it appears

The property that any two gears of a family will run together, which holds exactly when one cutter would produce both. It is why a gear standard is written as a description of a rack rather than as a family of tooth curves, and why a change of pressure angle makes a different family rather than a different gear.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

One cutter, five wheels. The same rack — one module, one pressure angle, one straight flank — rolled on five different pitch circles. Each wheel gets a different involute, of its own base circle, and the worst departure anywhere is 4.26e-14 mm. This is why gears are interchangeable: the tool defines the tooth, so any two wheels cut by the same rack mesh with each other whatever their tooth counts, and a workshop needs one cutter per module rather than one per pair. It is also why the standard is written as a rack — the rack is the definition and the wheels are consequences of it.

One rack and every wheel

Two gears mesh if they were cut by the same tool. That is not a manufacturing convenience laid on top of the geometry — it is the geometry, and it is why a gear standard is written as a description of a cutter rather than as a family of tooth curves.

gears · Tooth One tooth count, three pressure angles. A 20-tooth gear cut at 14.5°, 20°, 25°, drawn at a common pitch radius and overlaid on its own pitch and base circles. The three teeth have the same thickness at the pitch circle — that is what the standard fixes — and differ everywhere else: a coarser pressure angle puts the base circle lower and leans the flank over, so the tooth gains metal where it is held and loses it where it reaches: thicknesses at the base circle run 1.628, 1.756, 1.967 modules and at the tip 0.866, 0.695, 0.510. Those two run opposite ways, and the second of them ends at a hard stop — a tooth whose tip thickness reaches zero has come to a point and cannot be cut.

The angle the standard left free

Involute geometry fixes the tooth curve and leaves one number open. Raising it buys smaller pinions and spends contact ratio, monotonically and in opposite directions, so there is no angle that is best at both — and the familiar twenty degrees is a choice with a date on it rather than an optimum.

gears · Tooth

Named alongside it

The objects these essays reach for when they reach for this one.

Base circleInvoluteTooth thicknessUndercuttingCentre distanceConjugate-actionContact ratioDesign ruleGenerating rackLine of actionModulePressure angle

All concepts