Machine Kinematics
solved, then drawn
Concept

Parameterisation — where it appears

A choice of numbers for describing an object, which can be ill-conditioned or discontinuous where the object itself is perfectly ordinary. The distinction matters because a singularity of a description looks exactly like a singularity of a mechanism until somebody changes coordinates and it goes away.

Named by 3 essays across 2 fields — each of them below, with the objects they name alongside it.

SCARA, as four numbers a joint. A Denavit–Hartenberg table describes each joint by the common perpendicular between its axis and the next one: how long it is, how much the axes twist across it, where along the first axis it meets, and at what angle. 3 of these 3 rows have no answer for the last two, because the axes they describe are parallel and two parallel lines have infinitely many common perpendiculars, all the same length, at every point along them. The arm is perfectly ordinary; it is the description that has run out.

Four numbers or a screw

An arm can be written down as four numbers a joint or as a line in space with a pitch on it. Both are minimal, both describe the same machine to the last bit, and one of them jumps by three hundred and fifty thousand when an axis is tilted by a millionth of a radian.

serial · Serial Three points, three orders of contact. Replace the coupler point by a crank pivoting at the centre of its path's osculating circle, drive the linkage away from the instant, and measure how far the point gets from that circle. The distance grows like a power of the step, and the power is the number of derivatives that agreed. An ordinary point gives 3.00; a point of the cubic of stationary curvature gives 3.94; a Burmester point, where the curvature is stationary and its rate of change is too, gives 4.97. Nothing in the measurement knows which kind of point it was handed. This is what the two special curves are for: they are where a single pivot can replace a whole linkage for longest. positioned by solving, not by drawing.

How long a pivot stands in for a linkage

Throw the four-bar away and replace a coupler point by a crank pivoting at the centre of its path's curvature. The two separate like the cube of the crank step for an ordinary point, the fourth power on the cubic, and the fifth at a Burmester point — three exponents that are the whole field, measured with no derivative anywhere in the measurement.

curvature · Curvature What a calibration can and cannot see. The singular values of elbow arm's identification Jacobian — the matrix of how the tool pose moves when each model parameter is nudged, over 11 postures. There are 36 parameters and only 30 of them can be found: the last 6 directions come out at 2.3e-8, which is the difference noise, against 6.3e-4 for the weakest real one — a gap of 3e+4. And 30 is exactly 4R + 2P + 6 for this arm's 6 turning and 0 sliding joints, which is a count from the literature meeting a rank measured from the arm's own arithmetic.

What a calibration cannot see

A six-joint arm's model has thirty-six parameters and a measurement can find thirty of them. The other six are not hard to measure — they are combinations that move the tool by exactly nothing, at every posture, and no instrument ever built will separate them. The count is 4R + 2P + 6, and it comes out of a rank on four different arms.

serial · Serial

Named alongside it

The objects these essays reach for when they reach for this one.

ConditioningDenavit–Hartenberg parametersSerial manipulatorBall pointBurmester pointCalibrationCommon normalContact orderCubic of stationary curvatureForward kinematicsIdentificationJacobian

All concepts