Machine Kinematics
solved, then drawn
Concept

Rack cutter — where it appears

A straight-sided tool that generates an involute tooth by rolling on the blank's pitch circle. Standardising it standardises every wheel any workshop will ever cut with it, which is where interchangeability comes from.

Named by 2 essays across 2 fields — each of them below, with the objects they name alongside it.

Undercutting, either side of 17.10 teeth. Five gears, drawn whole and scaled to a common pitch circle so the tooth counts can be compared by counting them. The dedendum sits a fixed 1.25 modules below the pitch circle and the base circle sits at r·cos α, so as the tooth count falls the base circle rises relative to the root. Below N = 2/sin²α = 17.097 it rises above it, and the part of the flank between them lies where no involute exists — the cutter removes it. The familiar rule says seventeen; the exact figure is 17.10, so seventeen undercuts slightly and eighteen is the smallest count that does not. The teeth are not to a common scale, because at a common module the small gears would be unreadable.

Undercutting, and the seventeen-tooth rule

Below a certain tooth count a standard cutter eats into the flank it is supposed to be forming. The count is quoted as seventeen. The formula gives 17.097, which means seventeen undercuts slightly and eighteen is the smallest that does not — the rounding went the convenient way.

gears · Tooth A straight edge cutting a 24-tooth wheel. The rack's flanks are straight lines and its pitch line rolls on the wheel's pitch circle without slipping — 48 mm of travel per radian, which is the only number in the whole process. The dots are the contacts the meshing equation has returned so far, and they are the flank being cut: an involute, produced by a tool that has no curve anywhere on it. The corner of the rack traces the fillet below, which is a different curve for a different reason — a corner is a point, and a point has no envelope but its own path. positioned by solving, not by drawing.

The tool is the definition

There is no curve anywhere on the cutter that makes an involute gear. It is a straight edge, dragged past a turning blank, and the involute is what the motion leaves behind — along with a fillet that is a corner's path, a contact locus that comes out a straight line, and a base circle that is measured rather than drawn.

meshing · Meshing

Named alongside it

The objects these essays reach for when they reach for this one.

Base circleInvoluteConjugate-actionContact ratioEnvelopeGenerating rackLine of actionMeshMeshing equationPitchPitch pointPressure angle

All concepts