Machine Kinematics
solved, then drawn
Concept

Base pitch — where it appears

The spacing of successive contacts along a gear pair's line of action, equal to π times the module times the cosine of the pressure angle. It is the divisor in every contact ratio, and two gears mesh only if theirs agree.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

20 teeth driving 32. Both flanks generated from the involute, not approximated, at a pressure angle of 20°. The orange line is the line of action — tangent to both base circles, and the only place contact happens. Its length between the two tip circles divided by the base pitch is the contact ratio, 1.612 here, which means that for 61% of the cycle two tooth pairs are carrying the load and for the rest just one. The velocity ratio is 0.6250, and it is constant because the common normal never moves. The dashed extension runs between the two base tangency points, which are 8.89 mm apart; the heavy part is where contact actually happens.

What happens in a mesh

Contact between two gear teeth happens only along one straight line, and only over part of it. How much of that line lies between the two tip circles, divided by the base pitch, is the contact ratio — and if it drops below one the drive periodically stops being driven.

gears · Tooth The field of action, straight and slanted. The rectangle a contact lives in: its width is the usable line of action, its height is the face width, and a new contact line enters every base pitch. On the left the teeth are straight, so the lines are vertical and each one arrives and leaves all at once — the total length in contact jumps by a whole face width, 40 mm, every base pitch. On the right the same pair with a 20° helix: the lines lean by the base helix angle, so a tooth enters at one end of the face before it has left at the other, and the total changes by 3.44 mm instead of 40. Nothing about the profile is different between the two panels.

Contact that runs along the tooth

A straight tooth engages along its whole face at once, so the amount of contact at a mesh is a square wave. Slant the tooth and a second contact ratio appears that has no tooth count in it and no pressure angle — bought with face width and helix angle alone, and able to reach a value at which the total length of contact stops varying at all.

gears · Tooth

Named alongside it

The objects these essays reach for when they reach for this one.

Contact ratioInvoluteLine of actionMeshPressure angleUndercuttingBacklashBase circleDesign ruleOverlap ratioPeriodicityPitch

All concepts